When a small CNC lathe appears to announce that the spindle does not stop immediately, the following methods should be used:

1. The spindle motor is a variable frequency motor and has no brake. In such a situation, it is time to declare the command to stop, because there is spindle inertia;

2. For the servo motor, there will be a brake disc at the rear end of the general motor. This situation will occur when the friction plate is worn out. You can remove the friction plate or tighten the steel.

3. Check the brake pads on the bedside pulley and the brakes. The treatment method is as above;

4. If the above methods are not available, you can try to extend the time of the relay a little, not too long to avoid burning;

For more information about Shanghai Lathe Electromechanical Technology Co., Ltd. Shanghai lathe, Shanghai small CNC lathe, Shanghai CNC lathe, please contact Xiaobian.