What program is used to punch holes in CNC lathes?

The programming of punching with CNC lathe is the same as that of CNC lathe. The machining track of the drill bit is programmed according to the different processing technology. The following points should be noted in programming:

1. When installing the drill bit, consider the angle of the drill bit. Do not bias it. It is best to use the center to drill the center;

2. When the drill bit is set to the knife, the test is also used to test the enemies. Use the zero point of the end point of the drill bit, and the outer circle of the drill bit is rounded. Remember to add the drill radius;

3. When the punching process is not too fast, it is better to start a little and start to retreat a bit, with the discharge of iron filings and the entry of cutting oil;

4. If the hole is relatively large, it can be considered to drill a little earlier and then drill twice to the size;

5. In the process of programming, it should be programmed according to the difference of the data and the depth of the drilling to ensure a reasonable drilling process;

For more information about Shanghai Lathe Electromechanical Technology Co., Ltd. Shanghai lathe, Shanghai small CNC lathe, Shanghai CNC lathe, please contact Xiaobian.